SVD 4 inch 5-in-1 CCTV camera tester - how to test a CCTV camera on site

How to Test a CCTV Camera On Site Before You Mount It

Finding a bad camera after it's on the wall costs you a second trip up the ladder. Here's how to test a CCTV camera on the ground with a handheld tester, then once more at the end of the cable run, before you mount it.

How to Test a CCTV Camera: 5 Steps Before You Mount

ON THE GROUND1. Power from the testerCamera into the tester's DC12Voutput; check its rating first2. BNC in, match the formatTester set to TVI, AHD, CVI or CVBSto match the camera3. Check the pictureSharp, right color, no rolling;cover the front to test night mode4. Test at the cable endCamera powered at its spot, testerat the DVR end of the run5. Aim, then mountHold it in place, watch the view,fix it only when the picture is rightBad picture at any step? Fix it before you go up.

1. Power it from the tester

Plug the camera's power lead into the tester's DC12V output. Check the camera's rating first. The SVD 5MP 4-in-1 dome is rated DC12V/500mA. The 4" 5-in-1 tester and both SVD 7" testers supply 12V at up to 3A.

2. Connect BNC and match the format

Run a short BNC cable from the camera to the tester's BNC input. Set the tester to the camera's format: TVI, AHD, CVI or CVBS.

On a 4-in-1 camera, set the output to the format the DVR or monitor will read now, while it's in your hand. See how to identify TVI, AHD, CVI and CVBS. The 7" 7-in-1 tester supports coaxial control and menu debugging, so you can work in the camera's menu from the tester.

SVD 7 inch 7-in-1 CCTV tester monitor for testing security cameras on site

3. Check the picture

  • Sharp image, correct color, no rolling or lines.
  • Night mode: cover the front with your hand for a few seconds. The picture should drop to black and white, then return to color when you uncover it.

Bad picture here means the camera or its settings, not the cable. Rolling or stuck in black and white? See this fix guide. Otherwise swap the camera now.

4. Test again at the cable end

Once the cable is pulled, power the camera at its spot and plug the tester into the DVR end of the run. Picture at the camera but not here → the cable or BNC connectors. Re-terminate before you blame the DVR.

5. Aim, then mount

Hold the camera at the mounting spot with the tester connected and check the view covers what the client needs. Fix it in place only when the picture is right.

Need a tester for the van? Browse SVD CCTV testers.

Back to blog