SVD 8 channel 5-in-1 hybrid DVR - fixing a DVR no display on monitor problem

DVR Not Showing on the Monitor? Fixing HDMI and VGA Resolution Mismatch

The DVR is powered and recording, but there's no display on the monitor: just "No Signal," "Out of Range," or a black screen. If the recorder worked on a different screen, its HDMI or VGA output resolution is the first thing to check. Work through the four steps below in order.

DVR No Display on Monitor: Check in This Order

NO DISPLAY1. Input and cableMonitor set to HDMI or VGA to match;reseat both ends2. Native resolutionFind the monitor's native resolutionon its spec sheet or label3. Lower the DVR outputOn a screen that works: at or belownative, 60Hz. Then reconnect.4. Still blank? Swap to isolateCable, then output, then screenStop at the first step that fixes it.

1. Input and cable

Set the monitor's source to the input the DVR is plugged into, HDMI or VGA. Reseat both ends; on VGA, tighten both thumbscrews.

Make sure the monitor has that input at all. The 21.5" monitor has HDMI and BNC but no VGA, so connect the DVR by HDMI. The 18.5" monitor takes HDMI or VGA.

Rear inputs of the SVD 18.5 inch security monitor: HDMI, VGA, BNC, USB and audio

2. Find the monitor's native resolution

Check the spec sheet or the label on the back. For these SVD monitors:

Monitor Native resolution DVR inputs
18.5" 1366×768, 60Hz HDMI, VGA
21.5" 1920×1080, 60Hz HDMI

3. Lower the DVR's output resolution

  1. Connect the DVR to any screen that shows a picture, such as the monitor it came off or a TV with HDMI.
  2. In the DVR's display or output settings, pick a resolution at or below the new monitor's native resolution, at 60Hz. For a 1366×768 screen, that means the closest setting below it.
  3. Save, confirm the picture still shows, then move the cable back to the new monitor.

4. Still blank? Swap to isolate

  • Try a known-good HDMI or VGA cable.
  • If the DVR and monitor both have HDMI and VGA, try the other one. The SVD 8-channel 5-in-1 hybrid DVR, for example, has both outputs.
  • No picture on any screen → it's the DVR side. Check it has finished booting.
  • Every screen works except this one → test the monitor with another source, such as a laptop.

Cameras plugged straight into the monitor over BNC instead? Use our No Signal guide. Not sure which input to use? See BNC vs HDMI vs VGA.

Replacing the recorder? Browse SVD hybrid DVRs.

Back to blog